HWAMDAINJECTION MOLDING TEMPERATURE CONTROL
Mold Temperature Controllers
Stabilize the mold thermal condition with a controller selected around the process temperature, heat-transfer medium, circuit demand and production cell.
01 / PRODUCTION TASK
Control mold temperature at the process—not the room
A mold temperature controller circulates a heated or temperature-regulated medium through the mold. It supports repeatable thermal conditions while the chiller removes heat from the wider cooling loop.
Heat-transfer medium and water quality
Flow, pressure and connection review
Machine, mold and cooling-loop coordination
02 / OPERATING RELATIONSHIP
How the equipment fits the process
The flow below shows the functional relationship used for project review. Final piping, controls and connections follow the confirmed equipment.
- 01Temperature-control unit
- 02Pump circulation
- 03Mold channels
- 04Return circuit
- 05Temperature regulation
03 / EQUIPMENT CHOICE
Water or oil temperature control?
The medium follows the mold temperature your process needs: water units typically cover up to about 120 °C, oil units are used for higher temperatures.
Water-type controller
A common starting point when the required temperature and site water conditions fit a water circuit.
Oil-type controller
Considered when the process requires an operating range suited to a thermal-oil circuit.
04 / SELECTION INPUTS
What HWAMDA needs to match the equipment
With these inputs, HWAMDA can recommend equipment sized for your production rather than a generic model.
01Mold and molded product
02Resin and target mold temperature
03Required heating and heat-removal duty
04Circuit count, flow and pressure requirement
05Water quality and ambient conditions
06Power supply and connection standard
05 / PRODUCT CONFIGURATION
Matched to your mold and process temperature
Share the target mold temperature, number of circuits, mold size and site power supply. HWAMDA recommends the controller type, heating capacity and pump size for your mold as part of the production cell.
06 / PRODUCTION-CELL INTEGRATION
Connect the equipment to the complete molding cell
Review capacity and interfaces across the full sequence.
- 01Injection molding machine
- 02Mold temperature controller
- 03Mold thermal circuit
- 04Chiller / plant cooling loop
07 / APPLICATION REVIEW
Configure by product and production requirement
These application families can use the equipment when their material, mold and production conditions require it.
Thin-wall packagingIML packagingPaint bucketsPipe fittingsPlastic cratesGeneral technical parts
08 / BUYER QUESTIONS
Before selecting Mold Temperature Controllers
What is a mold temperature controller?
It is a circulating temperature-control unit used to regulate the mold thermal condition during injection molding.
Is a mold temperature controller the same as a chiller?
No. An MTC regulates the mold-side temperature, while a chiller is selected to remove process heat and provide cooling water.
Should I choose a water-type or oil-type MTC?
Selection depends on the required operating temperature, mold circuit, medium and approved equipment range.
What information is needed to select an MTC?
Provide the mold, resin, target temperature, circuit and connection details, utilities and plant conditions.
PROJECT INQUIRY
Get an MTC Recommendation
Send the production inputs you already know. Drawings, layout files and product photos can be attached for review.
- Mold and product
- Resin
- Target mold temperature
- Circuit / flow details
- Power supply
- Destination